Color:Two Replace your lost or broken keyless entry key fob remote with a USARemote Fob.Fits P/N: CWTWB1U545, 35111-S9V-325, 1788A-FWB1U5452005 2006 2007 2008 Honda PilotProgramming Instructions:Have all remotes for the vehicle on hand.Make sure all the doors and rear hatch/trunk are closed during programming.Only need to use 1 remote to get into program mode but all remotes must be programmed during the same session.Each step must be completed within 5 seconds.1. Sit in the car with all doors/trunk tightly closed2. Turn the key to the ON position, marked by ‘II’ on the ignition bezel so the dash lights come on, then within 5 seconds press the ‘Lock’ button on the remote for 1 second or so and release the button.3. Turn the key to the OFF position, marked by ‘I’ on the ignition bezel – dash lights go off.4. Repeat steps 2 & 3 three more times (A total of 4 times) â each step must be done within 5 seconds of the previous step.5. Upon the 4th turning of the key to ‘ON’, press the lock button on one remote, the locks will make a cycling sound (clunk), locks will NOT lock or unlock at this point, they will just make a noise. The system is now in programming mode. Do not turn key off.6. Within 5 seconds of entering programming mode and within 5 seconds of each other, press the lock button ON EACH remote you are programming, for a second or so and release. This step needs to be completed within 10 seconds. Each time a remote button is pushed, the locks should cycle. Up to 3 remotes can be programmed.7. Turn ignition completely off and remove the key. Step out of car and close door. The remotes should be programmed and should work. If you have a trunk/hatch release, the button for this feature needs to be held for a few seconds before the trunk/hatch will ‘pop’.This is a replacement aftermarket part.